Skip Navigation Website Accessibility
  • Hours of Operations
    Mon-Fri 10am - 6pm
    Saturday 9am - 4pm
    Sundays - Closed
  • Visit Our Store
    101 S Rainbow Blvd #11
    Las Vegas, NV 89145
    (1 Block North of Alta)

 
 

SeaSoft Ti Pro Hood

Color:
Size:
   
Quantity:    

Add to Cart
All of Seasoft's Titanium Pro Hoods have 5 different types of nylon-2 neoprene including compressed neoprene for the back-3 panels of the hood.

When diving, the deeper a diver goes the colder it generally gets and with increasing pressure, a typical neoprene hood gets thinner. If the temperature is getting colder and your hood is getting thinner, you're going to get cold. And, when you consider that 35% of heat loss is from the head area, it seems like this would be a place to make sure you are adequately protected to ensure warmth and comfort. 

All of Seasoft's Titanium Pro Hoods have 5 different types of nylon-2 neoprene including compressed neoprene for the back-3 panels of the hood. This means that no matter how deep you go, they are still their original thickness and working to keep you warm! You will not find any seams down the middle of the chin either. This seam, found in almost all hoods today, can cause jaw fatigue. The Seam is there because it is less expensive to make a hood from just two halves. We do not believe that a hood is the place to go cheap. 

The hood has titanium flakes foil technology that creates 2-layers of titanium Foil that reflects cold away and reflects your heat in keeping you warmer than hoods without this technology. The 3mm material is going to naturally fit and stretch around your head better. This leaves less room for cold water to occupy under your hood, this helps to maintain warmth as well. There are also two very small holes for air to escape from the inside crown of the hood in case air enters your hood with a thin baffle built over the holes to prevent water from entering. 

The Seasoft Pro3 Wetsuit Hood use 3mm neoprene with triple glued and double bond stitched seams for strength and durability. The edge of the bib is taped and sewn for additional strength. The hood is available in multiple sizes and is black in color.